en
de fr es

Global

Deutschland

France

Italia

España

United Kingdom

United States

Lietuva

Home
Support
Manuals
Monocular Pulsar 3x20 B
Monocular Installation

Monocular Pulsar 3x20 B
Manual
Monocular Pulsar 3x20 B

Table of contents

Monocular Installation

1. Align the protrusions on the monocular (1) on the side of its lens with the grooves of the mount (2) of the thermal imaging module.

2. Turn the monocular clockwise to secure it on the thermal imaging module. The recommended position of the clamping screw (3) is at the bottom (see Figure).

3. Turn on the thermal imaging module.

4. Adjust the eyepiece diopter ring (4) until the symbols in the display are sharp.

5. Loosen the screw (3) with an Allen key S3.

6. Align the display to the centre of the image in the monocular by tilting the thermal imaging module in the required directions.

7. Lock the monocular in the chosen position by tightening the screw (3) until it stops (clamping force – 2.5 Nm/ 22.13 in-lbs).

8. To remove the monocular, turn it counterclockwise and disconnect from the thermal imaging module.

Previous
Package Contents
Next
Legal Compliances and Disclaimers

Monocular Pulsar 3x20 B
Manual
Monocular Pulsar 3x20 B

×

from Yukon Group 2024