Manuals | Pulsar

When charging, always use the charger supplied with the riflescope. The use of any other charger may irreparably damage the Battery Pack or the charger and may cause fire.
The battery should be partially charged for long term storage. The recommended charge level is in range of 50% to 70%.
Do not charge the battery directly after moving the battery from a cold to a warm environment. Wait 30-40 minutes for the battery to reach room temperature.
During charging, do not leave the battery unattended.
Do not use the charger if its construction has been altered or damaged.
The battery should be charged at an air temperature of 0 ° C ... + 45 ° C.
Otherwise, lifespan of the battery will decrease significantly.
Do not leave the Battery Pack with a charger connected to the mains longer than 24 hours after full charge.
Do not expose the battery pack to high temperature or to a naked flame.
Do not submerge the battery.
Do not connect external device with a current consumption that exceeds permitted levels.
The Battery Pack is brief circuit protected. However, any situation that may cause short-circuiting should be avoided.
Do not disassemble or deform the battery.
Do not expose the battery to shocks and drops.
When using the battery at low temperatures, the battery capacity decreases, this is normal and not a defect.
Do not use the battery at the temperatures above those shown in the table – this may decrease battery’s life.
Keep the battery out of the reach of children.

Manual

Digisight Ultra LRF