Powering on and Adjusting the IR Illuminator

1. Make sure that the illuminator is mounted and connected to the device. To do this, turn on the device and check that there is no icon on the display.
2. To turn on the IR illuminator, briefly press the ON/OFF (2) button on the end of the illuminator. When turning on the power level is minimum ().
3. To switch the power level ( ,  or ), briefly press the ON/OFF (2) button of the IR illuminator.
4. The IR illuminator icon showing the appropriate power level ( ,  or ) is displayed in the status bar on the display of the digital device.
5. To align the position of the light spot in the field of view, turn the lens lock knob (4) of the IR illuminator to the OPEN position.
6. By rotating the lens of the IR illuminator, achieve the required position of the light spot in the field of view. After successful adjustment, rotate the lock knob towards the CLOSE while holding the lens in the desired direction to lock the IR illuminator lens.
7. To turn off the illuminator, press and hold the ON/OFF (2) button on the end of the illuminator.

Notes:

• When the IR illuminator is turned off or removed, the power level is not saved in the memory of the device.
• The infrared illuminator is powered by the digital device.