Rangefinder

Menu item Rangefinder allows you to set up built-in rangefinder’s parameters as follows:

1. Enter the main menu with a long press of the controller button (6).
2. Rotate the controller ring (6) to select the submenu Rangefinder  .
3. Enter the submenu with a short press of the controller button (6).
4. Rotate the controller ring (6) to select the desired menu item.

Reticle Type

1. Rotate the controller ring (6) to select the Reticle Type  menu item.
2. Press briefly the controller button (6) to enter submenu.
3. Rotate the controller ring (6) to select one of the three reticle shapes .
4. Confirm selection with a brief press of the controller button (6).
5. The selected reticle will appear on the display.
6. The reticle will disappear from the display if the rangefinder is not used longer than 4 seconds.

TPA

Function "TPA" (Target Position Angle) allows you to measure the angle of target location (angle of elevation). When the function is activated, the angle is shown continuously.

1. Rotate the controller ring (6) to select TPA .
2. Turn TPA on/off with a short press of the controller button (6).

THD

"THD" (True Horizontal Distance) function allows you to measure true horizontal distance to a target based on the angle of elevation value.

1. Rotate the controller ring (6) to select THD .
2. Turn THD on/off with a short press of the controller button (6).
3. Hereinafter the message THD will appear above the distance readings.​​​