en
lt

Global

Deutschland

France

Italia

España

United Kingdom

United States

Lietuva

Home
Support
Manuals
Forward F455S
Display Calibration

Forward F455S
Manual
Forward F455S

Table of contents

Display Calibration

The attachment is configured so that after fitting onto an optical riflescope that had been properly zeroed, no adjustment of the aiming point is required. Yet if point of impact change is observed after putting on the attachment, you can fix it with display calibration procedure.

  1. To enter display calibration mode, first press and hold the M (7) button for 10 seconds.
  2. The display coordinates X=0; Y=0 will appear.
  3. Use the LEFT (8) and RIGHT (6) buttons to move the display horizontally (X axis) and vertically (Y axis) so that the point of impact moves to the center of the riflescope reticle.
  4. Press the M (7) button to toggle between the X and Y coordinates.
  5. The image offset range is +/- 20 pixels horizontally (X axis), +/- 20 pixels vertically (Y axis).
  6. To exit the menu and save the settings, press and hold the M (7) button for two seconds.
 
Previous
Using the Weaver Rail
Next
Stream Vision 2

Forward F455S
Manual
Forward F455S

×

from Yukon Group 2024