en
lt

Deutschland

Italia

España

United Kingdom

United States

Lietuva

Digex C50
Manual
Digex C50

Table of contents

Installing the IR Illuminator on Riflescope

  1. Open the mount ring (24) of the IR illuminator.
  2. Raise the eccentric lever (26) and put the mount on the riflescope body so
    that the mount half rings encircle the riflescope body.
  3. Align the eccentric axis (25) with the groove (30) of the moving half ring.
  4. Lock the eccentric lever (26) position by lowering it down.
  5. The IR illuminator mount should be as close as possible to body of the riflescope lens.
  6. In case of loosening or insufficient fixing of the IR-illuminator on the riflescope, raise the eccentric lever (26). Tighten the eccentric axis (25) 1-2 turns using the supplied Allen key. Then lower the lever and check the fixation of the IR-illuminator on the riflescope. If necessary, repeat the above steps until the required degree of fixation of the IR-illuminator is achieved.