Battery Charging

1. Insert the battery* (1) along the guide to the stop into the APS-V charger slot (4) (see. Fig.).
2. Point D on the APS 2/3 battery and Point C on the charger should be aligned.
3. Connect the plug of the USB Type-C cable (7) to the USB Type-C connector of the power adapter (3). 
4. Connect the other end of the USB Type-C cable to the USB Type-C connector (5) of the charger (4) by removing the USB Type-A adapter.
5. Plug the power adapter (3) into a socket 100-240 V (6) (110 V socket for US).
6. LED indication (2) displays battery charging level (see Table).
7. Two batteries can be charged at the same time. Slot A is for APS 5 and APS 5T batteries. Slot B is for APS 3 and APS 2 batteries.

LED indication (2) in the battery charging mode	Battery Level
	Battery level is from 0% to 25%
	Battery level is from 26% to 50%
	Battery level is from 51% to 80%
	Battery level is from 81% to 99%
	The battery is fully charged. Charging will automatically stop. The battery can be disconnected from the charger.
	Defective battery. It is forbidden to use the battery.

LED indication (2) in the standby mode**	Battery Level
	Battery level is from 0% to 25%
	Battery level is from 26% to 50%
	Battery level is from 51% to 80%
	Battery level is from 81% to 99%
	The battery is fully charged. It can be disconnected from the charger.
	Defective battery. It is forbidden to use the battery.

* Purchased separately or supplied as package contents of a device.

** Standby mode – an operating mode in which batteries are inserted into the charger, but the power adapter is not connected. In this mode, the indication is on for 10 seconds.

Attention! When charging an APS 5 or APS 5T battery with a power adapter that does not support USB fast charging technology, the charge time increases and it is indicated by a slow flashing LED light.

Attention! The charger heats up during fast charging. Excess heat is removed through the radiator and does not affect the device operation.