Mounting the Attachment on the Adapter​​​

Step 1. Mount the attachment on the adapter

1. Remove the protective cover from the eyepiece of the attachment.

2. Align the protrusions on the adapter (13) with the grooves of the mount assembly (18) of the attachment and turn the attachment counterclockwise as far as it will go.

Step 2. Adjust the display position of the attachment

1. Loosen the screw (14) with an Allen key (S = 4mm).

2. Turn on the attachment by briefly pressing the ON/OFF (8) button.

3. Align the display center with the crosshairs of the reticle by tilting the attachment. You can activate the auxiliary cross on the display in the "Display Alignment" section of the main menu.

4. Tighten the screw (14) as far as it will go. The clamping force should be 5 N·m (44.3 in-lbs) (use the torque screwdriver to check).

5. Move the lever (17) to the OPEN position.

6. Align top and bottom display boundaries parallel to the horizontal axis of the optical sight by turning the attachment clockwise or counterclockwise.

7. Move the lever (17) to the CLOSE position.