Powering on and Image Settings

1. Remove the lens cover (1) by turning it counterclockwise.
2. Press the ON/OFF (9) button to turn on the thermal imager.
3. Adjust the eyepiece dioptre ring of your daylight optical device until the symbols in the display are sharp. In future, it will not be necessary to adjust the eyepiece dioptre, regardless of the distance and other conditions.
4. Rotate the lens focus knob (10) to focus on the visual target.
5. Enter the main menu with a long press of the MENU (7) button and select the desired calibration mode: manual (M), semi-automatic (SA) or automatic (A).
6. Calibrate the image by briefly pressing the ON/OFF (9) button.
7. Close the lens cover when calibrating manually.
8. Select the desired observation mode (Forest, Rocks, Identification or User) by briefly pressing the MODE (8) button or in the main menu. User mode allows you to configure and save custom brightness and contrast settings, as well as one of three modes as a base.
9. Select one of the two color palettes by a long press of the MODE (8) button.
10. Activate the quick menu by briefly pressing the MENU (7) button to adjust the brightness and contrast of the display (see the Quick Menu Functions section for details).
11. Upon completion of use turn the device off by a long press of the ON/OFF (9) button.

Attention! The lens of the device must not be pointed at any sources of intense energy, such as laser-emitting devices or the sun. This may damage the electronic components in the device. Damage caused by failure to comply with the operating guidelines is not covered under warranty.